Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Front Propeller Shaft Nut

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
1	Front Propeller Shaft Nut CAUTION: Do not reuse the flange nut. Reusing the flange nut may cause damage to the transmission. NOTE: Remove and DISCARD the propeller shaft flange nut. Special Tools DT-45012 Holding Fixture For equivalent regional tools, refer to Special Tools .
2	Propeller Shaft Transmission Flange NOTE: If the propeller shaft transmission flange is not easily removed with DT-45012 holding fixture use DT-38416-B harmonic balancer remover to remove the flange. Special Tools DT-38416-B Harmonic Balancer Remover DT-45012 Holding Fixture For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Front Propeller Shaft Nut

CAUTION:

Do not reuse the flange nut. Reusing the flange nut may cause damage to the transmission.

NOTE:

Remove and DISCARD the propeller shaft flange nut.

Special Tools
DT-45012 Holding Fixture
For equivalent regional tools, refer to Special Tools .

Propeller Shaft Transmission Flange

NOTE:

If the propeller shaft transmission flange is not easily removed with DT-45012 holding fixture use DT-38416-B harmonic balancer remover to remove the flange.

Special Tools

DT-38416-B Harmonic Balancer Remover
DT-45012 Holding Fixture

For equivalent regional tools, refer to Special Tools .