Single Use Fasteners and Components
WARNING: This page is about a different variant/trim than selected.
Front Propeller Shaft Nut
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| 1 | Propeller Shaft Transmission Flange |
| 2 | Front Propeller Shaft Nut
CAUTION:
Refer to Fastener Caution . Procedure Install a NEW nut. Tighten 105 N.m (77 lb ft) Special Tools DT-45012 Holding Fixture For equivalent regional tools, refer to Special Tools . |
| 3 | Output Shaft
CAUTION:
Stake the flange nut onto the output shaft. Use the two staking grooves on the shaft to locate the staking points. Failure to stake the flange nut may result in damage to the transmission. |