Wiring Harness Removal

WARNING: This page is about a different variant/trim than selected.

GM4974608

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Wiring Harness Removal

Callout	Component Name
1	Automatic Transmission Control Wiring Harness Clip Bracket Bolt [2x]
2	Automatic Transmission Wiring Harness NOTE: Ensure the connector is free of debris and dirt. Procedure Disconnect the Transmission Range Selector (TRS) connector. Install the DT-52089-1 Wiring Harness Pass Through Connector Removal Tool onto the bulkhead connector. Ensure that the DT-52089-1 Wiring Harness Pass Through Connector Removal Tool is pushed all the way on and flush with the transmission case. Push the DT-52089-2 Wiring Harness Pass Through Connector Removal Tool into the DT-52089-1 Wiring Harness Pass Through Connector Removal Tool and remove the bulkhead connector from the case. Special Tools DT-52089 Wiring Harness Pass Through Connector Removal Tool Equivalent regional tools: Special Tools
3	Automatic Transmission Control Wiring Harness Retainer Procedure Remove and DISCARD the retainer.
4	Wiring Harness Connector Seal O-Ring [2x] Procedure Remove and DISCARD the O-ring seal.
5	Automatic Transmission Control Wiring Harness Retainer Procedure Remove and DISCARD the retainer.