Control Valve Body Assembly Bolt Removal

WARNING: This page is about a different variant/trim than selected.

GM6215169

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Control Valve Body Assembly Bolt Removal

Callout	Component Name
1	Electrical Connector Procedure Unlock the connector latch.
2	Electrical Connector Procedure Disconnect the main control wiring harness connector.
3	Control Valve Solenoid Body Bolt [2x] Procedure The bolts are marked by arrows in the valve body casting.
4	Control Valve Solenoid Body Bolt [3x] Procedure The bolts are marked by arrows in the valve body casting. Remove and DISCARD the bolts, they are not reusable.
5	Control Valve Solenoid Body Bolt [2x] Procedure The bolts are marked by arrows in the valve body casting.
6	Control Valve Solenoid Body Bolt NOTE: Control valve solenoid body bolt shown in dashed box should NOT be removed. If removed during disassembly, the bolt must be replaced using NEW bolt with sealant.