Wiring Harness Installation

WARNING: This page is about a different variant/trim than selected.

GM4974610

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Wiring Harness Installation

Callout	Component Name
1	Wiring Harness Connector Seal - O-Ring [2x] Procedure Install a NEW seal.
2	Automatic Transmission Control Wiring Harness Retainer [2x] Procedure Install a NEW retainer.
3	Automatic Transmission Wiring Harness Procedure NOTE: Ensure the bulkhead connector is fully snapped into the case and seated flush. Install the wiring harness. Connect the Transmission Range Selector (TRS) connector. Ensure the TRS connector wire is routed under the retaining tab as shown (a).
4	Automatic Transmission Control Wiring Harness Clip Bracket Bolt [2x] CAUTION: Refer to Fastener Caution . Procedure Tighten bolts after speed sensor installation. One of the speed sensor wires needs to be routed under a retainer tab on this harness. Tighten 9 N.m (80 lb in)
5	Automatic Transmission Control Wiring Harness Retainer [2x] Procedure Install a NEW retainer.