Speed Sensors Installation

WARNING: This page is about a different variant/trim than selected.

GM4481985

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Speed Sensors Installation

Callout	Component Name
1	Automatic Transmission Turbine Speed Sensor NOTE: The bolt is retained in the harness. Procedure Install Sensor and bolt. Connect to harness, green connector to green connector. Tighten 9 N.m (80 lb in)
2	Automatic Transmission Intermediate Speed Sensor - A NOTE: The bolt is retained in the harness. Procedure Install Sensor and bolt. Connect to harness, brown connector to brown connector. Tighten 9 N.m (80 lb in)
3	Automatic Transmission Intermediate Speed Sensor - B NOTE: The bolt is retained in the harness. Procedure Install Sensor and bolt. Connect to harness, blue connector to blue connector. Tighten 9 N.m (80 lb in)
4	Automatic Transmission Output Speed Sensor NOTE: The bolt is retained in the harness. Procedure Install Sensor and bolt. Connect to harness, blue connector to blue connector. Tighten 9 N.m (80 lb in)