Control Valve Body Assembly Bolt Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts in the following chart represent components shown in graphic above.
Control Valve Body Assembly Bolt Installation
| Callout | Component Name |
|---|---|
| 1 | Control Valve Solenoid Body Bolt [2x] Procedure Tighten 9 N.m (80 lb in) |
| 2 | Control Valve Solenoid Body Bolt [3x]
NOTE:
The bolts are marked by arrows in the valve body casting. Procedure Install a NEW bolt. Tighten 9 N.m (80 lb in) |
| 3 | Control Valve Solenoid Body Bolt [2x] Procedure Tighten 9 N.m (80 lb in) |
| 4 | Control Valve Solenoid Body Bolt
NOTE:
Bolt shown in dashed box should not be removed. If removed during disassembly, the bolt must be replaced using new bolt with sealant. Procedure Install a NEW bolt. Tighten
|