LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Automatic Transmission - 10L60, 10L80 Or 10L90 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Case Extension Assembly Removal >> Single Use Fasteners and Components

Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Automatic Transmission Case Extension Seal

  1. GM5427455Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Before removing the automatic transmission case extension, place the transmission in a vertical position with the case extension facing up. Failure to do so may result in damage to the transmission output shaft bearing and/or sleeve.

    Automatic Transmission Case Extension Bolt (1) - Remove [6x]

  2. Allow any remaining transmission fluid to drain from the case extension.
  3. Automatic Transmission Case Extension (2) - Remove
  4. Automatic Transmission Case Extension Seal (3) - Remove and DISCARD