Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Input Shaft Support Bolt [12x]

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
1	Input Shaft Support Bolt [12x] Procedure Remove and DISCARD the bolts.
2	Automatic Transmission Case Cover CAUTION: The automatic transmission fluid pump MUST be removed before installing the automatic transmission case front cover. Failure to do so may result in damage to the fluid pump driven gear and case front cover idler gear Procedure Using a paint pen, mark the Automatic Transmission Case Coverand Transmission Case for orientation during installation. Special Tools DT-45053 Universal Clamp Press Equivalent regional tools: Special Tools

Callout

Component Name

Input Shaft Support Bolt [12x]
Procedure
Remove and DISCARD the bolts.

Automatic Transmission Case Cover

CAUTION:

The automatic transmission fluid pump MUST be removed before installing the automatic transmission case front cover. Failure to do so may result in damage to the fluid pump driven gear and case front cover idler gear

Procedure
Using a paint pen, mark the Automatic Transmission Case Coverand Transmission Case for orientation during installation.
Special Tools
DT-45053 Universal Clamp Press
Equivalent regional tools: Special Tools