LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Automatic Transmission - 10L60, 10L80 Or 10L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Manual Shift Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the exhaust muffler. Exhaust Muffler Replacement (LGX, Coupe) , or Exhaust Muffler Replacement (LGX, Convertible) , or Exhaust Muffler Replacement (LT1, LT4, Coupe) , or Exhaust Muffler Replacement (LT1, LT4, Convertible)
  2. GM4179436Courtesy of GENERAL MOTORS COMPANY

    If equipped, remove the underbody rear brace (2). Underbody Rear Brace Replacement (Convertible)

  3. Remove the automatic transmission range selector lever cable from the transmission. Automatic Transmission Range Selector Lever Cable Replacement 
  4. Remove the control valve body. Control Valve Body Replacement 
  5. GM4278196Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission mount (4). Transmission Mount Replacement 

  6. Lower the rear of the transmission until there is enough clearance to remove the manual shift shaft.
  7. GM4540962Courtesy of GENERAL MOTORS COMPANY

    Remove and DISCARD the manual shift shaft pin (1).

  8. GM4540965Courtesy of GENERAL MOTORS COMPANY

    Remove the manual shift shaft (1).