Transmission Mount Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
NOTE: The transmission support and the transmission mount are replaced as an assembly. Preliminary Procedures Raise and support the vehicle. Lifting and Jacking the Vehicle (ZL1) , or Lifting and Jacking the Vehicle (Convertible) Support the transmission with a suitable jack.
1	Shift Control Cable Bolt [2X] CAUTION: Refer to Fastener Caution Tighten 9 N.m (80 lb in)
2	Transmission Support Crossmember Bolt [4X] Tighten 58 N.m (43 lb ft)
3	Transmission Mount Bolt [2X] Tighten 58 N.m (43 lb ft)
4	Transmission Support Crossmember