Single Use Fasteners and Components
WARNING: This page is about a different variant/trim than selected.
- Drivetrain and Front Suspension Cradle Front Bolt [2x]
- Drivetrain and Front Suspension Cradle Interior Bolt [2x]
- Drivetrain and Front Suspension Cradle Rear Bolt [2x]
- Engine Mount Bolt [2x]
- Front Lower Control Arm Front Bolt [2x]
- Front Lower Control Arm Rear Bolt [2x]
NOTE:
Callouts items in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
|
Preliminary Procedures |
|
| 1 | Engine Mount Nut
CAUTION:
Refer to Fastener Caution . Procedure Working under the hood, remove the engine mount upper fastening nut. Tighten 70 N.m (52 lb ft) |
| 2 | Engine Mount Bolt [2x]
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure
Tighten
|
| 3 | Engine Mount Procedure Using the engine support fixture, raise the engine enough to remove the engine mount. |
| 4 | Engine Mount Vacuum Hose |
| 5 | Phenolic Spacer
CAUTION:
Phenolic spacer must be present to prevent galvanic/corrosive reaction and/or excessive temperature conduction between engine mount bracket and engine mount. Replace mount if phenolic spacer is missing or damaged. Failure to ensure phenolic spacer is intact and not damaged can lead to premature failure of engine mount and/or engine mount bracket. Procedure Inspect the engine mount to ensure the phenolic spacer is in place and not damaged. |