Engine Support Fixture
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts items in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Front Bumper Fascia Center Support Replacement . Special Tools
Equivalent regional tools: Special Tools . |
|
| 1 | EN-36857
Engine Lift Bracket [2x]
CAUTION:
Refer to Fastener Caution . Procedure Use EN-52059 Engine Support Fixture Adapter Bolt - M10 to install a EN-36857 bracket to the right and left cylinder head in the location shown. Tighten the bolt to 65 N.m (48 lb ft). |
| 2 | EN-51007 - 1
Main Support Beam Procedure Install main support beam through engine support beam adapters and pin in place. |
| 3 | EN-51007 - 6 Hook Assembly (Qty: 2) |
| 4 | EN-28467 - 6A Bracket Assembly (Qty: 2) |
| 5 | EN-51007 - 4
Cross Bracket (Qty: 2) Procedure Loosely install cross bracket to retain radiator shelf tube to main support beam. Tighten cross bracket after front support assembly is in place. |
| 6 | EN-51007 - 3
Radiator Tube Shelf Assembly (Qty: 2) Procedure Place radiator shelf tubes on top of main support beam. |
| 7 | EN-51007 - 5
Front Support Assembly (Qty: 2) Procedure Place front support assembly through radiator tube shelf and pin at proper height. |