Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Cover, Bolt, Seal -- With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

Place a bead 8 mm (0.3150 in) in width by 4 mm (0.1575 in) in height of RTV sealant equivalent, on the engine front cover split lines (1). Adhesives, Fluids, Lubricants, and Sealers
Camshaft Cover Seal (2) - Install a NEW seal.
Camshaft Cover (3) - Install
Camshaft Cover Bolt (4) - Loosely install [18x]

CAUTION:

Tighten in the sequence shown. 15 N.m (11 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Position the fuel feed pipe and install the fuel feed pipe bolt (1). Fuel Feed Pipe Replacement (LGX at Engine)Fuel Feed Pipe Replacement (Fuel Tank To Engine LGX)
Position and install the engine harness to the camshaft cover.
Courtesy of GENERAL MOTORS COMPANY

Camshaft Position Actuator Valve Solenoid (2) - Install - Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Intake
Courtesy of GENERAL MOTORS COMPANY

Camshaft Position Actuator Valve Solenoid (2) - Install - Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust
Courtesy of GENERAL MOTORS COMPANY

Ignition Coil (2) - Install [3x] - Ignition Coil Replacement - Bank 1
Positive Crankcase Ventilation Tube@Camshaft Cover - Connect
Courtesy of GENERAL MOTORS COMPANY

Camshaft Housing Cover Insulator- Right Side (1) - Install - Camshaft Housing Cover Insulator Replacement - Right Side