Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Intake Manifold Gasket (1) - Install NEW
Intake Manifold (2) - Install
- Intake Manifold Bolt (1) - Loosely install [5x]
Intake Manifold Bolt (1) - Loosely install
-
CAUTION:
Refer to Fastener Caution .
Tighten the bolts in the sequence shown.
- First Pass: 12 N.m (106 lb in)
- Final Pass: 12 N.m (106 lb in)
- Generator - Install - Generator Replacement (LTG - with V18) , or Generator Replacement (LTG - without V18)
Engine Mount Vacuum Hose Extension (1) @Intake Manifold - Connect - Engine Mount Vacuum Hose Extension Replacement
- Lower the vehicle. Lifting and Jacking the Vehicle (ZL1) , or Lifting and Jacking the Vehicle (Convertible)
Radiator Inlet Pipe Bolt (2) - Install and tighten - Radiator Inlet Pipe Replacement (LTG)
- Throttle Body Assembly - Install - Throttle Body Assembly Replacement
Connect the electrical connectors (1-4).
- Wiring Harness Retainer (3) - Install [2x]
- Connect the evaporative emission pipe to the intake manifold retainer (5).
Radiator Surge Tank (2) - Install - Radiator Surge Tank Replacement (LTG)
Evaporative Emission Canister Purge Solenoid Valve (1) - Install - Evaporative Emission Canister Purge Solenoid Valve Replacement
Fuel Pump Insulator (2) - Install - Fuel Pump Insulator Replacement (Inner) , or Fuel Pump Insulator Replacement (Outer)
- Plenum Front Panel - Install - Plenum Front Panel Replacement (LTG LGX)