LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Spark ACTIV, Standard Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake and Accelerator Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  2. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
  3. Remove the I/P knee bolster. Refer to Instrument Panel Knee Bolster Replacement .
  4. Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
  5. Remove the steering column assembly. Refer to Steering Column Replacement .
  6. Disconnect the electrical connectors from the accelerator pedal and brake pedal position sensor, if equipped.
  7. GM4114299Courtesy of GENERAL MOTORS COMPANY

    Remove the retaining clip (1) and pin (2) from the brake pedal.

  8. Disconnect the brake booster pushrod (3) from the brake pedal.
  9. GM4114311Courtesy of GENERAL MOTORS COMPANY

    Remove the brake and accelerator pedal bracket nuts (1).

  10. Remove the brake and accelerator pedal assembly (2) from the vehicle.
  11. Remove the following components from the brake and accelerator pedal assembly, as necessary.
    • Accelerator pedal assembly
    • Brake pedal position sensor or brake pedal position switch
    • Brake pedal assembly
scientia non olet · About LEMON Manuals