Transmission Case

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
The end of the bearing that has numbers stamped on it must face the J 44384 bearing installer, so that the numbers are visible when the bearing is installed.

Install the 1st/2nd and the 3rd/4th shift shaft bearing. Use the J 36190 driver handle (1) and the J 44384 bearing installer (2).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Bearings and Races are replaced as sets.

Install the mainshaft bearing race (3), using the J 8092 driver handle (1) and the J 39435 installer (2).
Courtesy of GENERAL MOTORS COMPANY

Install the countershaft bearing race (3), using the J 8092 driver handle (1) and the J 39435 installer (2).
Courtesy of GENERAL MOTORS COMPANY

Install the dowel pins (1) and magnet (2). Use Loctite H3300 Speedbonder Structural Adhesive. Adhesives, Fluids, Lubricants, and Sealers (MJK, MH3, or MM6)
Courtesy of GENERAL MOTORS COMPANY

Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads of the transmission case fill plug (1), the temperature sensor (3) and the cooler line return fitting (2).
Courtesy of GENERAL MOTORS COMPANY

Install the transmission case cooler line return fitting (1) and tighten to 22 N.m (16 lb ft).
Install the transmission case fill plug (2) and tighten to 27 N.m (20 lb ft).
Install the coolant temperature sensor (3) and tighten to 39 N.m (29 lb ft).
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
The H-pattern on the guide plate must face the extension housing. If the guide plate is installed incorrectly, then damage will occur.

Install the guide plate (2) and the guide plate bolts (1) and tighten to 22 N.m (16 Ib ft).