Inverter Lever Install

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Temporarily remove the clutch housing bolts (1).
Courtesy of GENERAL MOTORS COMPANY

Temporarily remove the clutch housing assembly (1).
Courtesy of GENERAL MOTORS COMPANY

Install the manual transmission selector lever (1).
Courtesy of GENERAL MOTORS COMPANY

Install the manual transmission selector lever pivot pin (1). Tighten to 41 N.m (30 lb ft). Adhesives, Fluids, Lubricants, and Sealers (M13)
Courtesy of GENERAL MOTORS COMPANY

Install the manual transmission shift lever retainer (1).
Courtesy of GENERAL MOTORS COMPANY

Install the clutch housing assembly (2), clutch housing gasket (3), and the the clutch housing bolts (1). Tighten to 33 N.m (24 lb ft).