LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 6.2L - Repair Instructions (1 Of 2)) >> Repair Instructions >> Cylinder Head Replacement - Right Side (LT4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. For cylinder head assemble. Refer to Cylinder Head Assemble (LT4) .
  2. Clean any debris or residual fastener thread sealant from the engine block cylinder head bolt holes to ensure proper torque or clamp load.
  3. Install the cylinder head. Refer to Cylinder Head Installation - Right Side .
  4. Install the ground wire and bolt at the rear of the cylinder head. Tighten the bolt to 15 N.m (11 lb ft)
  5. Install the exhaust manifold and the exhaust manifold to cylinder head bolts. Refer to Exhaust Manifold Replacement - Right Side (LT1, LT4) .
  6. Install the spark plugs. Refer to Gas Engine Ignition Spark Plug Replacement .
  7. Install the push rods and valve rocker arms. Refer to Valve Rocker Arm and Push Rod Replacement .
  8. Install the engine coolant manifold. Refer to Engine Coolant Manifold Replacement (LT4)
  9. Install the supercharger and gasket. Refer to Compressor Air Intake Supercharger and Gasket Replacement .
  10. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (LT4) .
  11. Refill the intercooler cooling system. Refer to Charge Air Cooling System Draining and Filling (LT4) .
  12. Refill the engine cooling system. Refer to Cooling System Draining and Filling (GE 47716) , or Cooling System Draining and Filling (Static Fill) .
  13. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals