LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 6.2L - Repair Instructions (1 Of 2)) >> Repair Instructions >> Cylinder Head Replacement - Right Side (LT1) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine coolant manifold. Engine Coolant Manifold Replacement (LT1) .
  2. Remove the fuel injector rail. Fuel Injection Fuel Rail Assembly Replacement - Bank 2 (LT1) .
  3. Remove the exhaust manifold. Exhaust Manifold Replacement - Right Side (LT1, LT4) .
  4. Remove the ground wire bolt from the rear of the cylinder head and position the ground wire away.
  5. Remove the valve rocker arms and push rods. Valve Rocker Arm and Push Rod Replacement .
  6. GM3273430Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure to DISCARD all cylinder head bolts.

    Remove and DISCARD the cylinder head bolts (1).

  7. Remove cylinder head (2).
  8. Remove and DISCARD cylinder head gasket (3). Replacing Engine Gaskets .
  9. Clean and inspect the cylinder head. Cylinder Head Cleaning and Inspection .
  10. Disassemble the cylinder head as necessary. Cylinder Head Disassemble (LT1) .
scientia non olet · About LEMON Manuals