LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Bolt EV >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Automatic Transmission - 10L60 (MQA) Or 10L80 (MHU) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pump Driven Gear Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5143929Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Fluid Pump Driven Gear (1) - Install

  2. Automatic Transmission Fluid Pump Drive Shaft Retaining Ring (2) - Install NEW
  3. Automatic Transmission Fluid Pump Driven Gear Baffle (3) - Install
  4. GM5111991Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Fluid Pump (1) - Install

  5. Automatic Transmission Fluid Pump Seal (2) - Install NEW
    6. CAUTION:

    Refer to Fastener Caution .

  6. Automatic Transmission Fluid Pump Bolt (3) - Install and tighten [3x] - Fastener Specifications
  7. GM5111987Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the automatic transmission fluid pump seal is in the control valve body.

    Control Valve Body Assembly (1) - Install

    8. NOTE:

    The locating pins on the bottom of the control valve body assembly will hold the control valve body assembly in place while installing bolts.

  8. Install the control valve body assembly into the case.
    9. NOTE:

    Ensure the wiring harness is not pinched anywhere after valve body installation.

  9. Connect the main control wiring harness connector as shown.
  10. Park Inhibitor Solenoid (2) - Install
  11. GM5111981Courtesy of GENERAL MOTORS COMPANY

    Clean the bolt holes and ensure they are free from any old sealant. Allow to dry before installing NEW bolts.

    12. CAUTION:

    Refer to Fastener Caution

  12. Control Valve Solenoid Body Bolt (1) - Install and tighten in sequence [2x] - Fastener Specifications
    13. NOTE:

    The bolts are marked by arrows in the valve body casting.

  13. Control Valve Solenoid Body Bolt (2) - Install NEW and tighten in sequence [3x] - Fastener Specifications
  14. Control Valve Solenoid Body Bolt (3) - Install and tighten in sequence [2x] - Fastener Specifications
  15. GM5428681Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Auxiliary Fluid Pump Seal (1) - Install NEW

  16. Automatic Transmission Auxiliary Fluid Pump Outlet Pipe Seal (2) - Install NEW
  17. Automatic Transmission Auxiliary Fluid Pump Outlet Pipe (3) - Install
  18. Control Valve Upper Body Bolt (4) - Install and tighten - Fastener Specifications
  19. GM5427502Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Fluid Filter (2) - Install - Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement 

  20. Remove the drain pan.
  21. Lower the vehicle.
  22. Fill the transmission to the proper level with NEW transmission fluid. Transmission Fluid Level and Condition Check
  23. Perform the solenoid valve characterization reprogramming procedure. Q77 Transmission Control Solenoid Valve Characterization Programming (8L45) , or Q77 Transmission Control Solenoid Valve Characterization Programming (10L60, 10L80)
scientia non olet · About LEMON Manuals