Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Connect the electrical connector.
- Automatic Transmission Electronic Control (2) - Install
- Automatic Transmission Control Bolt (1) - Install and tighten [4x] - Fastener Specifications
Wiring Harness Retainer (1) - Install [2x]
Connect the electrical connector.
- Front Floor Console Trim Plate (1) - Install
Front Floor Console Trim Plate Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Front Floor Console Variable 1 Liner (1) - Install
Slide the front floor console (1) back into the instrument panel.
Front Floor Console Bolt (1) - Install and tighten [6x] - Fastener Specifications
- Front Floor Console Bracket Bolt (2) - Install and tighten [2x] - Fastener Specifications
Front Floor Console Extension Panel - Right Side (1) - Install
- Return the seat to its original position.
Front Floor Console Extension Panel - Left Side (1) - Install
- Return the seat to its original position.
- If replacing the automatic transmission electronic control, perform the programing and setup procedures as necessary. K212 Gear Shift Control Module: Programming and Setup
CAUTION:
Refer to Fastener Caution .