Liftgate Replacement (Power)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedures Liftgate Upper Center Trim Finish Panel Replacement Liftgate Strut Replacement (Power) Liftgate Power Assist Actuator Replacement
1	Liftgate Hinge Bolt [4x] CAUTION: Refer to Fastener Caution . Mark the position of the hinges with a grease pencil. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps: Remove any loose cured adhesive from the external threads of the components using a lint free cloth. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers Ensure there are no gaps in the thread locking adhesive once applied to the component. Tighten 22 N.m (16 lb ft)
2	Liftgate Procedure Disconnect the electrical connectors and rear window washer solvent container hose. With the aid of an assistant, remove the liftgate. Transfer components as necessary. Adjust liftgate as needed. Liftgate Adjustment

Callout

Component Name

WARNING:

When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedures

Liftgate Hinge Bolt [4x]

CAUTION:

Refer to Fastener Caution .

Mark the position of the hinges with a grease pencil.
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

Tighten
22 N.m (16 lb ft)

Liftgate

Procedure

Disconnect the electrical connectors and rear window washer solvent container hose.
With the aid of an assistant, remove the liftgate.
Transfer components as necessary.
Adjust liftgate as needed. Liftgate Adjustment