Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Transmission Mount (2) - Install
- Transmission Mount Bolt (1) - Install and tighten [2x] 100 N.m (74 lb ft)
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Transmission Mount Transmission Side Bolt (1) - Install NEW and tighten [3x]
- First Pass: 100 N.m (74 lb ft)
- Final Pass: 60 - 75 degrees
- Remove the engine support fixture. Engine Support Fixture
- Battery Tray @ Vehicle - Install - Battery Tray Replacement
CAUTION: