Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Tank Filler Pipe (1) - Install
Fuel Tank Filler Hose (3) - Install
- Fuel Tank Filler Hose Clamp (2) - Install and tighten 3.5 N.m (31 lb in)
- Evaporative Emission Canister Vent Hose (1) - Connect - Plastic Collar Quick Connect Fitting Service
Tie Strap (3) - Install NEW [6x]
- Fuel Tank Filler Pipe Bracket Nut (2) - Install and tighten 9 N.m (80 lb in)
- Fuel Tank Filler Pipe Ground Bolt (1) - Install and tighten 9 N.m (80 lb in)
Retainer (3) - Install
- Tie Strap (2) - Install NEW
- Fuel Tank Filler Pipe Bolt (1) - Install and tighten 2.5 N.m (22 lb in)
- Rear Wheelhouse Liner-Left Side - Install - Rear Wheelhouse Liner Replacement
- Fuel Tank Filler Pipe Housing - Install - Fuel Tank Filler Pipe Housing Replacement
- Refill the fuel tank.
CAUTION:
Refer to Fastener Caution .