LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 2.0L (LSY) - Repair Instructions) >> Repair Instructions >> Charge Air Cooler Inlet Air Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5219422Courtesy of GENERAL MOTORS COMPANY

    Evaporative Emission Canister Purge Tube (1) - Remove - Evaporative Emission Canister Purge Tube Replacement 

  2. GM5219424Courtesy of GENERAL MOTORS COMPANY

    Evaporative Emission Hose (1) - Remove - Evaporative Emission Hose Replacement 

  3. Heater Outlet Hose - Reposition - Heater Outlet Hose Replacement (LSY)
  4. Radiator Surge Tank - Reposition - Radiator Surge Tank Replacement (LSY)
  5. GM5064240Courtesy of GENERAL MOTORS COMPANY

    Charge Air Cooler Inlet Air Tube Bolt (1) Remove

  6. Retainer Spring (2) - Release
  7. Charge Air Cooler Inlet Air Tube (3) @ Charge Air Cooler Inlet Air Hose Adapter (4) - Remove
  8. Raise and support the vehicle. Lifting and Jacking the Vehicle
  9. Remove the 3 front lower bolts from the left front wheelhouse liner and reposition liner. Front Wheelhouse Liner Replacement
  10. GM5341973Courtesy of GENERAL MOTORS COMPANY

    Retainer Spring (1) - Release

  11. Charge Air Cooler Inlet Air Tube (2) - Remove
scientia non olet · About LEMON Manuals