LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L (LSY)) >> Repair Instructions >> Engine Support Fixture >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5368146Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Some components not shown for graphic clarity.

    Remove the EN-51007  Global Engine Support Fixture (1).

  2. GM5107550Courtesy of GENERAL MOTORS COMPANY

    EN-51768  Engine Support Fixture Adapter Bolt M8 (2) - Remove

  3. J-36857  Engine Lift Bracket Set (1) - Remove
  4. GM5679858Courtesy of GENERAL MOTORS COMPANY

    Ground terminal (1) - Reposition

  5. Engine Lift Bracket Bolt (2) - Install
  6. GM5107549Courtesy of GENERAL MOTORS COMPANY

    EN-51768  Engine Support Fixture Adapter Bolt M8 (2) - Remove

  7. J-36857  Engine Lift Bracket Set (1) - Remove
  8. GM5106831Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Bracket (2) - Install

    9. CAUTION:

    Refer to Fastener Caution .

  9. Engine Wiring Harness Bracket Bolt (1) - Install and tighten 22 N.m (16 lb ft)
  10. GM5106805Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) @ Engine Wiring Harness Bracket (2) - Install [2x]

  11. Intake Air Splash Shield - Install - Intake Air Splash Shield Replacement
  12. Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement
  13. Air Cleaner Outlet Intermediate Duct - Install - Air Cleaner Outlet Intermediate Duct Replacement
scientia non olet · About LEMON Manuals