Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Accessory Drive Primary Belt Routing
Courtesy of GENERAL MOTORS COMPANY

Accessory Drive Primary Belt (1) - Remove - Accessory Drive Primary Belt Replacement
Courtesy of GENERAL MOTORS COMPANY

Starter Motor (1) - Remove - Starter Replacement (LSY)
Courtesy of GENERAL MOTORS COMPANY

Install the EN-52476 Flywheel Holding Tool (1) through the starter mounting hole to the Automatic Transmission Flex Plate (2).
Remove the right front tire and wheel assembly. Tire and Wheel Removal and Installation
Front Wheelhouse Liner- Right Side - Remove - Front Wheelhouse Liner Replacement
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The timing pin feature must be retracted during the balancer bolt removal.

Crankshaft Balancer Bolt (1) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

Crankshaft Balancer (1) - Remove