Installation Procedure
- Using the outline made by the spray paint or marker, position the transmission mount to the drivetrain and front suspension cradle.
- CAUTION:
Refer to Fastener Caution .
CAUTION:Refer to Torque-to-Yield Fastener Caution .
Install the NEW transmission rear mount bolts (2) and nuts and tighten the bolts to 100 N.m (74 lb ft) plus 95 to 105 degrees.
- Install the transmission mount to bracket through bolt (1) and tighten to 100 N.m (74 lb ft).
- Raise the rear of the front suspension cradle into place.
- Install the left and right side front cradle rear braces. Front Cradle Rear Brace Replacement
- Install the underbody front air deflector. Underbody Front Air Deflector Replacement
- Remove the jack stand.
- Lower the vehicle.