LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 9T50 (M3D), 9T60 (M3T) Or 9T65 (M3V) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (All Wheel Drive) >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle .
  2. Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
  3. Remove the two piece propeller shaft. Two-Piece Propeller Shaft Replacement .
  4. Using a suitable jack stand, support the rear of the powertrain.
  5. Remove the left and right side front cradle braces. Front Cradle Rear Brace Replacement
  6. Carefully lower the rear of the front suspension cradle to gain access to the transmission mount bracket bolts.
  7. GM4708558Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission mount to bracket through bolt (1).

    8. NOTE:

    The nuts are reusable.

  8. Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
  9. Remove the transmission rear mount.
scientia non olet · About LEMON Manuals