Removal Procedure
- Place the ignition switch in the OFF position.
- Without disconnecting the hoses, remove and position aside the radiator surge tank. Radiator Surge Tank Replacement
- NOTE:
Master cylinder not shown for clarity.
NOTE:Do NOT loosen the power brake booster bolts completely.
Power Brake Booster Bolt (1) - Loosen [2x]
- Front Floor Console Extension Panel - Left Side - Remove - Front Floor Console Extension Panel Replacement - Left Side
- Brake Pedal Position Sensor - Remove - Brake Pedal Position Sensor Replacement
- Accelerator Pedal with Position Sensor Electrical Connector - Disconnect
- With the aid of an assistant, hold the power brake booster away from the dash panel.
Brake Pedal Retainer (1) - Release
- Brake Pedal (2) - Release
- Completely loosen the 2 power brake booster bolts.
Brake Pedal Bracket Bolt (1) - Remove
Brake Pedal Bracket Bolt (1) - Remove [2x]
- Reposition the brake and accelerator pedal assembly and release the wire harness retainer.
- Brake Pedal Assembly - Remove
Brake Pedal Retainer (1) - Remove and DISCARD
Accelerator Pedal with Position Sensor Assembly (1) - Remove - Accelerator Pedal with Position Sensor Assembly Replacement
NOTE:
Pull the brake pedal rearward.