Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Accelerator Pedal with Position Sensor Assembly (1) - Install - Accelerator Pedal with Position Sensor Assembly Replacement
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Retainer (1) - Install NEW

NOTE:

Align the power brake booster pushrod with the brake pedal retainer.

Brake Pedal Assembly - Install
Position the brake and accelerator pedal assembly and secure the wire harness retainer.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Pedal Bracket Bolt (1) - Install and tighten [2x] 15 N.m (11 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Bracket Bolt (1) - Install and tighten 15 N.m (11 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Retainer (1) - Install
Brake Pedal (2) - Secure
Accelerator Pedal with Position Sensor Assembly Electrical Connector - Connect
Brake Pedal Position Sensor - Install - Brake Pedal Position Sensor Replacement
Front Floor Console Extension Panel - Left Side - Install - Front Floor Console Extension Panel Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft)
Reposition and install the radiator surge tank. Radiator Surge Tank Replacement