Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Ignition Coil - Remove - Ignition Coil Replacement
- Vacuum Pump - Remove - Vacuum Pump Replacement
- Positive Crankcase Ventilation Tube@Air Cleaner Outlet Duct - Disconnect - Plastic Collar Quick Connect Fitting Service
- Turbocharger Heat Shield - Remove - Turbocharger Heat Shield Replacement
- NOTE:
The PCV hose and fitting assembly (2) is a permanent connection. Reinstall these components as an assembly unless new components are being used.
NOTE:Always ensure the PCV hose fitting O-Ring (3) seal is free of cuts or abrasions each time the fitting is attached to the turbocharger.
Positive Crankcase Ventilation Hose Fitting Bolt (1) - Remove
- Positive Crankcase Ventilation Hose Fitting (2) - Disconnect
- Turbocharger Coolant Return Pipe - Remove - Turbocharger Coolant Return Pipe Replacement (LTG)
- Oil Level Indicator - Remove
- Engine Coolant Air Bleed Pipe - Remove - Engine Coolant Air Bleed Pipe Replacement (LTG)
- Camshaft Position Actuator Intake Solenoid Valve - Remove - Camshaft Position Actuator Intake Solenoid Valve Replacement
- Camshaft Position Actuator Exhaust Solenoid Valve - Remove - Camshaft Position Actuator Exhaust Solenoid Valve Replacement
- Camshaft Cover Heat Shield - Remove - Camshaft Cover Heat Shield Replacement
- NOTE:
Note the location of the four long camshaft cover bolts (2) for proper installation.
Camshaft Cover Bolt (1, 2) - Remove [23x]
- Camshaft Cover (3) - Remove
Camshaft Cover Gasket (1) - Remove and DISCARD
- If reinstalling the camshaft cover (2), clean and inspect as needed. Camshaft Cover and Compressor Air Intake Turbocharger Cleaning and Inspection