Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Install a NEW gasket.
NOTE:Add 14mm bead of sealant at right and left T-Joint where front cover meets head and at rear of camshaft cover right and left T-Joint where vacuum pump bolts on.
Camshaft Cover Gasket (1) - Install
Camshaft Cover (3) - Install
- Camshaft Cover Bolt (1, 2) - Loosely install [23x]
- CAUTION:
Refer to Fastener Caution .
Tighten the camshaft cover bolts in sequence to 10 N.m (89 lb in).
- Camshaft Cover Heat Shield - Install - Camshaft Cover Heat Shield Replacement
- NOTE:
Always ensure the PCV hose fitting O-Ring seal (3) is free of cuts or abrasions each time the fitting is attached to the turbocharger.
Inspect the O-ring and replace if necessary. (3)
- Positive Crankcase Ventilation Hose Fitting (2) - Connect
- Positive Crankcase Ventilation Hose Fitting Bolt (1) - Install and tighten 8 N.m (71 lb in)
- Camshaft Position Actuator Exhaust Solenoid Valve - Install - Camshaft Position Actuator Exhaust Solenoid Valve Replacement
- Camshaft Position Actuator Intake Solenoid Valve - Install - Camshaft Position Actuator Intake Solenoid Valve Replacement
- Install the engine oil level indicator.
- Turbocharger Heat Shield - Install - Turbocharger Heat Shield Replacement
- Turbocharger Coolant Return Pipe - Install - Turbocharger Coolant Return Pipe Replacement (LTG)
- Engine Coolant Air Bleed Pipe - Install - Engine Coolant Air Bleed Pipe Replacement (LTG)
- Positive Crankcase Ventilation Tube@Air Cleaner Outlet Duct - Connect - Plastic Collar Quick Connect Fitting Service
- Vacuum Pump - Install - Vacuum Pump Replacement
- Ignition Coil - Install - Ignition Coil Replacement
NOTE:
Ensure the long camshaft cover bolts (2) are installed in the correct positions.