LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (Left Side) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4940174Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Engine Control Module Bracket removed for clarity.

    Install the left transmission mount (5) to the vehicle.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Transmission Mount Bolt (4) - Install and tighten [2x] 100 N.m (74 lb ft)
  3. Transmission Mount Transmission Side Bolt (3) - Install NEW and tighten [4x]
    1. First Pass:100 N.m (74 lb ft)
    2. Final Pass:60-75 Degrees
  4. Position the transmission mount bracket (2) to the vehicle.
  5. Engine Mount Brace Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft).
  6. Remove the transmission jack.
  7. Install the Engine Wiring Harness Fuse Block Bracket. Engine Wiring Harness Fuse Block Bracket Replacement
  8. Install the battery tray. Battery Tray Replacement (LTG)
scientia non olet · About LEMON Manuals