Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Manual Shift Detent Lever Shaft (3) - Install
- Using DT-51436 Manual Shaft Pin Installer, install a NEW Manual Shift Shaft Pin (4).
- Manual Shift Detent Lever Pin (5) - Install
- Manual Shift Detent Lever Spring (11) - Install and tighten to 12 N.m (106 lb in)
- Automatic Transmission Wiring Harness Bracket - Install - Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation
- Control Valve Body Cover Replacement - Install
- Automatic Transmission Range Selector Lever Replacement - Install
- Range Selector Lever Cable @ Automatic Transmission Range Selector Lever - Install - Range Selector Lever Cable Replacement
- Range Selector Lever Cable Adjustment - Adjust
CAUTION:
The manual shift shaft pin must be installed before the manual shift detent lever pin. Use the special tool, DT-51436, to install the manual shift shaft pin to the proper depth. Failure to follow these steps may result in damage to the transmission.