Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
The felt tape covering the microphone brackets is single use. Please discard the used tape. New tape has been supplied for use after the microphones have been re-installed. Verify that the paper tape backing has been removed from the headliner before re-installing.

With the aid of an assistant, position the headliner trim panel assembly (2)into the vehicle through the front windshield.
Connect the electrical connectors.
Tape any unused connectors to the headlining with a high adhesive tape.
Install the [2x] headliner trim panel retainers. (1)
Windshield Replacement - Install
Courtesy of GENERAL MOTORS COMPANY

Active Noise Cancellation Microphone Grille Replacement (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Window Panel Trim Replacement (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Windshield Multifunction Sensor Mount Bracket Cover Replacement (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Coat Hook Replacement (2) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Center Reading Lamp Replacement (Without Sunroof) (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Roof Console Replacement (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Center Pillar Upper Trim Panel Replacement (1) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Quarter Window Trim Finish Panel Replacement (3) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Windshield Garnish Molding Replacement (1) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Roof Rail Assist Handle Replacement (2) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Sunshade Support Replacement (2) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Sunshade Replacement (3) - Install[2x]
Enable the SIR System. SIR Disabling and Enabling