Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Rear Suspension Lower Control Arm (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Suspension Lower Control Arm Adjust Bolt (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Coil Spring Lower Insulator (2) - Install
Rear Coil Spring (1) - Install
Rear Coil Spring Insulator (3) - Install
Courtesy of GENERAL MOTORS COMPANY

Raise the rear suspension lower control arm (1) back into position.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Rear Suspension Lower Control Arm Adjust Cam (2) - Install
Rear Suspension Lower Control Arm Inner Nut (1) - Install and tighten 90 N.m (66 lb ft)
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Rear Suspension Lower Control Arm Outer Bolt (2) - Install a NEW bolt.
Rear Suspension Lower Control Arm Outer Nut (1) - Install
Tighten
1. First Pass: 160 N.m (118 lb ft)N.m
2. Final Pass: (90-105 degrees)
Courtesy of GENERAL MOTORS COMPANY

Rear Shock Absorber Bolt (2) - Install a NEW bolt.
Rear Shock Absorber Nut (1) - Install
Tighten
1. First Pass: 160 N.m (118 lb ft)N.m
2. Final Pass: (90-105 degrees)
Courtesy of GENERAL MOTORS COMPANY

Rear Stabilizer Shaft Link Bolt (2) - Install
Rear Stabilizer Shaft Link Nut (1) - Install and tighten 58 N.m (43 lb ft)
Remove the support from the rear suspension lower control arm.
Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation
Verify the rear camber specifications and adjust as necessary. Rear Camber Adjustment