Removal Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- WARNING:
Refer to Glass and Sheet Metal Handling Warning .
WARNING:If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
NOTE:Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.
High Mount Stop Lamp (2) - Remove - High Mount Stop Lamp Replacement
- Electrical - Disconnect
- Carefully cut around the lace, start in the center working from side to side of the window to access the urethane adhesive bead.
- Keep the cutting edge of the tool against the window, this will allow the urethane adhesive to be separated from the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
With the aid of an assistant lift the rear window (1) from the opening.