Installation Procedure
With the aid of an assistant, carefully lower the body to the frame. (1)
Drivetrain and Front Suspension Support Bolt (1) - Hand tighten [4x]
Use CH-51034-A Cradle Alignment Pins to align the cradle to the body. (1)
- CAUTION:
Refer to Fastener Caution
Drivetrain and Front Suspension Support Bolt (1) - Tighten [4x] 160 N.m (118 lb ft)
- Drivetrain and Front Suspension Support Bolt (2) - Install and tighten [6x] 58 N.m (43 lb ft)
- Remove the EN-39580 stand from under the vehicle.
- NOTE:
During cradle removal, additional care may be needed at transmission mount bracket to assist in separation.
Transmission Mount Strut Bracket (2) - Install - Transmission Mount Strut Bracket Replacement (Rear)
Front Stabilizer Shaft Link (1) @Front Stabilizer Shaft - Install - Stabilizer Shaft Link Replacement
Lower Control Arm (1) @Knuckle - Install - Lower Control Arm Replacement
Steering Linkage Outer Tie Rod (3) @Knuckle - Install - Steering Linkage Outer Tie Rod Replacement
Underbody Front Air Deflector (2) - Install - Underbody Front Air Deflector Replacement
Front Bumper Fascia Air Deflector (2) - Tighten - Front Bumper Fascia Center Air Deflector Replacement
Exhaust Front Pipe (3) - Install - Exhaust Front Pipe Replacement (LTG)
Intermediate Steering Shaft (2) - Install - Intermediate Steering Shaft Replacement
Connect the steering gear electrical connectors. (1)
- Wiring Harness Retainer (2) - Engage [2x]
- Install the front tires and wheels. Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Remove the engine support fixture.