Rear Parking Assist Alarm Sensor Bracket Replacement: Notes

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Rear Bumper Fascia Energy Absorber (2) - Remove - Rear Bumper Fascia Energy Absorber Replacement
Courtesy of GENERAL MOTORS COMPANY

Rear Parking Assist Alarm Sensor (1) - Remove - Rear Parking Assist Alarm Sensor Replacement
Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed tool, carefully remove the rear parking assist alarm sensor bracket (1) from the fascia.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do Not sand/grind off alignment tabs / outline.

Using an appropriate tool, sand/grind sonic weld plastic residue from the fascia (1).