LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Automatic Transmission - VT40 (MRG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the range selector lever cable to vehicle by installing it from the interior.
  2. GM4932626Courtesy of GENERAL MOTORS COMPANY

    Range Selector Lever Cable (3) @ Transmission Control - Install

    CAUTION:

    Fastener Caution

  3. Install the 2 range selector lever cable screws (1, 2) and tighten to 9 N.m (80 lb in).
  4. GM5115990Courtesy of GENERAL MOTORS COMPANY

    Transmission Range Selector Lever Cable Grommet Nut (1) - Install and tighten [2x] 6.5 N.m (58 lb in)

  5. Front Floor Console - Install - Front Floor Console Replacement
  6. GM4953113Courtesy of GENERAL MOTORS COMPANY

    Install the range selector lever cable (4) to the range selector lever cable lever.

  7. Automatic Transmission Range Selector Lever Cable Bolt (1) - Install and tighten 9 N.m (80 lb in)
  8. Depress the cable adjustment retainer (3) locking the retainer completely.
  9. Slide the retainer lock (2) rearward to cover the cable adjustment retainer (3).
  10. Range Selector Lever Cable - Adjust - Range Selector Lever Cable Adjustment 
  11. Install the battery tray. Battery Tray Replacement (LFV)
scientia non olet · About LEMON Manuals