Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Manual Shift Detent Lever (3) - Install
- Park Pawl Actuator (4) - Install
- Manual Shift Detent Lever Shaft (2) - Install
- Install the NEW manual shaft detent lever hub pin (1) to height of 7.9 mm (0.31 in) (a).
Manual Shift Detent Lever Spring (2) @ Manual Shift Detent Lever - Install
CAUTION:Manual Shift Detent Spring Bolt (1) - Install and tighten the NEW bolt. 9 N.m (80 lb in)
- Control Valve Body - Install - Control Valve Body Replacement
- Range Selector Lever Cable Lever - Install - Range Selector Lever Cable Lever Replacement
NOTE:
Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.