LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Replacement (With Base)

Transmission Control Replacement (With Base)

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
GM4196225Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Front Floor Console Replacement
  2. WARNING:

    After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

  3. Automatic Transmission Range Selector Lever Cable@Transmission - Disconnect - Automatic Transmission Range Selector Lever Cable Replacement 
  4. Disconnect the electrical connectors.
1 Transmission Control Nut [4x]
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Transmission Control