Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to HVAC Module Drain Tube Caution .

Heater and Air Conditioning Evaporator and Blower Module (1) - Remove - Heater and Air Conditioning Evaporator and Blower Module Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

If equipped remove the heater and air conditioning evaporator and blower module insulator (1) from the heater and air conditioning evaporator and blower module.
Courtesy of GENERAL MOTORS COMPANY

Heater and Air Conditioning Evaporator and Blower Module Screw (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Conditioning Wiring Harness - Disconnect as necessary
Unlatch the heater and air conditioning evaporator and blower case (1) from the air conditioning evaporator case indicated by the arrows.
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Housing (1) - Remove - Air Inlet Housing Replacement
Courtesy of GENERAL MOTORS COMPANY

Unlatch the heater and air conditioning evaporator and blower upper case (1) from the heater and air conditioning evaporator and blower lower case (2) indicated by the arrows.
Courtesy of GENERAL MOTORS COMPANY

Unlatch the heater and air conditioning evaporator and blower upper case (1) from the heater and air conditioning evaporator and blower lower case (2) indicated by the arrows.
Courtesy of GENERAL MOTORS COMPANY

Separate and remove the heater and air conditioning evaporator and blower lower case (1) from the heater and air conditioning evaporator and blower upper case (2).
Transfer components as necessary.