Fuel Injector Removal
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
EN-51146 Fuel Injector Removal/ Installation Kit
Equivalent regional tools:Special Tools
Remove the 8 plate bolts (1) and remove EN-51146-1-2 plate (2), counterhold with a wrench (4) at the EN-51146-1-1 supports (3).
- Remove the regarding EN-51146-1-1 supports (3).
Fuel Injector Wiring Harness (2) - Disconnect [4x]
- Fuel Injector (3) @ Fuel Injection Fuel Rail (1) - Remove [4x]
O-Ring (1) @ Fuel Injector (2) - Remove and DISCARD
NOTE:
Remove only the EN-51146-1-1 supports (3) of the fuel injector or fuel injectors, which will be replaced. The EN-51146-1-1 supports must be installed at the injectors, which will be re-used. Failure to follow this caution could cause leaks or malfunction after installation.