Special Tools
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
| Illustration | Tool Number/ Description |
|---|---|
| CH-42188-B J-42188-B Ball Joint Separator |
|
| CH-51034 Cradle Alignment Guide Pin |
|
| DT-523-1 KM-523-1 Centring manrel, handle |
|
| EN-498-B KM-498-B CH-48027 J-21867-L40 Pressure Gauge |
|
| EN-571-B Dial Gauge |
|
| EN-652 KM-652 J-42618 Flywheel Holder |
|
| EN-840 KM-840 Pliers Remover |
|
| EN-956-1 KM-956-1 Extension |
|
| EN-958 KM-958 Valve Stem Seal Installer |
|
| EN-6106 KM-6106 Adapter |
|
| EN-6216 MKM-6216 Gauge |
|
| EN-6216-200/300/400 MKM-6216-200/300/400 |
|
| EN-8062 J-8062 Valve Spring Compressor |
|
| EN-8087 J-8087 Cylinder Bore Gauge |
|
| EN-28467-501 J-28467-501 Engine Support Fixture Adapters |
|
| EN-28467-B J-28467-B Universal Engine Support Fixture |
|
| EN-36462-A J-36462-A Engine Support Adapter Leg Set |
|
| EN-36857 J-36857 Engine Lift Bracket |
|
| EN-45000 J-45000 Seal Remover |
|
| EN-45059 J-45059 Angle Meter |
|
| EN-45059 - A Angle Meter |
|
| EN-47909 Injector Bore Brush Set |
|
| EN-48259 Oxygen Sensor Remover/Installer |
|
| EN-49155 Valve Spring Compressor Adapter |
|
| EN-49941 Caliper, piston pin retainer ring |
|
| EN-49979 Retainer Shock Mount Crankshaft |
|
| EN-50513 Locking Pin |
|
| EN-50717 Valve Spring Compressor |
|
| EN-51146 Fuel Injector Remover-Installer |
|
| EN-51148 Camshaft Holding Tool |
|
| EN-51149 Spark Plug Remover / Installer |
|
| EN-51150 Compression Test Adapter |
|
| EN-51151 Crankshaft Rear Oil Seal Installer |
|
| EN-51152 Crankshaft Front Oil Seal Installer |
|
| EN-51511 Injector Port Service Plug |
|
| EN-51841 Stretchy Belt Installer |
|
| J-44389 Countershaft Bearing Installer |