Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Brake Fluid Irritant Warning

CAUTION:

Brake Fluid Effects on Paint and Electrical Components Caution

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

High Voltage - Disable - High Voltage Disabling
Without draining the coolant and without disconnecting the hoses, remove and position aside the radiator surge tank. Radiator Surge Tank Replacement (LKN)
Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
Disconnect the EBCM electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder Hose Brake Pipe Fitting (1) - Disconnect
Cap the fitting and plug the BPMV port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Right Rear Brake Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Left Rear Brake Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Right Front Brake Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Left Front Brake Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Nut (1) - Loosen
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Bolt (1) - Remove
Electronic Brake Control Module with Brake Pressure Modulator Valve - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket (1) - Remove - Brake Pressure Modulator Valve Bracket Replacement