Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket (1) - Install - Brake Pressure Modulator Valve Bracket Replacement
Electronic Brake Control Module with Brake Pressure Modulator Valve - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Pressure Modulator Valve Bracket Bolt (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Nut (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Bracket Nut (1) - Tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Left Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Right Front Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Left Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Right Rear Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder Hose Brake Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Connect the EBCM electrical connector.
Radiator Surge Tank Replacement (LKN) - Install
High Voltage - Enable - High Voltage Enabling
Program the EBCM. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering
Bleed the brake system. Antilock Brake System Automated Bleed