LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Impala Premier >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Assembly Replacement (With Accelerator and Bracket) >> Removal Procedure

Removal Procedure

  1. Remove the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement .
  2. Disconnect the accelerator pedal position sensor electrical connector.
  3. GM2347572

    Pull the brake pedal (1) rearward to release the power vacuum brake booster pushrod retainer.

    4. NOTE:

    Do not reuse the power vacuum brake booster pushrod retainer.

  4. Remove and discard the power vacuum brake booster pushrod retainer.
  5. Remove the instrument panel tie bar. Refer to Instrument Panel Tie Bar Replacement .
  6. GM2280912

    Remove the power vacuum brake booster (1). Refer to Power Vacuum Brake Booster Replacement .

  7. GM2347575

    Remove the brake pedal assembly nut (1).

  8. Remove the brake pedal assembly.
scientia non olet · About LEMON Manuals